Drill America T/A Series High-Speed Steel Hand Threading Tap Set, Uncoated (Bright) Finish, Round with Square End Shank, #6-32 Size (Pack of 1)

CUSTOMER REVIEW



Works as it should. Not much else you can say.

Big Gator Tools V Tap and V Drill Guides - Complete tool set of 6 Guides

CUSTOMER REVIEW



Every workshop & DIY should have a set of these. They make the job, simpler, more accurate and the end result is quality product.

Vermont American 21662 8-Inch 32 NC Number 29 High Carbon Steel Tap and Drill Bit Combo Set

CUSTOMER REVIEW



I do not need to tap holes very often. Therefore it is great to buy a tap with the proper sized drill bit (no error possible selecting the right bit). I was tapping aluminum sheet so there was not much challenge for the tool. All holes in the parts were cleanly cut and screwed together easily.
I labeled and taped the pair together ready for when I may need them again.

Jancy Slugger U19014 1/2" Chuck And Adapter Accessory For Holemaker II Magnetic Drill

CUSTOMER REVIEW



The chuck appears to be of high quality, though I have not had a chance to use it yet. I purchased it because I want to drill and tap fixture hold downs on my 1" thick welding table. The annular cutters work well for through bolts, but are the wrong drill sizes for taps. My intent is the drill first with the annular cutters to the closest undersize then run one or more drills using this chuck to get the proper size hole required for the tap.

Drill America DWT Series Qualtech High-Speed Steel Hand Threading Tap Set, Uncoated (Bright) Finish, Round with Square End Shank, #4-40 Size (Pack of 1)

CUSTOMER REVIEW



Works as it should. Not much else you can say.

Makita XPH012 18V LXT Lithium-Ion Cordless 1/2-Inch Hammer Driver-Drill Kit with One Battery

CUSTOMER REVIEW



Makita LXT drills and drivers a hard to beat. I contracted for years and use to use mostly DeWalt and Bosch. Four years ago it was time to replace my Bosch 18v NiCd drill and impact. I was pretty set on just getting another Bosch kit, but found a good deal on the Makita LXT combo. With moderately hard use, it has held up without issue every since. When I found this driver on sale for $99, I just couldn't pass.

Black & Decker BDC120VA100 20-Volt MAX Lithium-Ion Drill Kit with 100 Accessories

CUSTOMER REVIEW



This drill/driver provides adequate torque (300lb vs the typical 400-450lb of a comparable 18v/20v drill/driver), and it's sufficient for the homeowner who plans to use it quite sparingly. Despite B&D being not considered seriously among contractors, they actually build decent stuff- after all, they're the parent company of DeWalt. It's a decent value, but there's one glaring problem: It only includes ONE battery, which means your projects are forced to a screeching halt while you wait out the recharge period (unless you happen to have multiple drills, like me). This can be extremely frustrating.

This drill would be a good choice if you already own compatible BD batteries for other devices. If not, you may want to consider buying something with two batteries for just a few bucks more, like the Dewalt 18v driver for $99 or so.